 |
4 Spndle Unit |
|
 |
The main spindle are hardened, Precision ground and supported by precision double row cylindrical roller bearings and angular contact bearings.
The cartridge type spindles are lubricated with grease and sealed less maintenance.
※Top:Loading/Unloading Area Bottom:Cutting Area |
|
|
High Accuracy Indexing |
|
8-Station Turrets. |
|
|
|
 |
|
 |
|
|
|
The spindles are mounted in a carrier drum, Whose exterior is a large diameter curvic coupling thus insuring high accuracy, rigidity and repeatablity when positioning. |
|
High speed, bi-directional, random indexing employs a revolutionary designed 3-piece curvic-coupling. On optional turrets, OD / ID tooling can be mounted at any position on the tool turrets. |
|
|
|
|
Chip Conveyor |
|
Hydraulic Unit |
|
Box-Shaped Slideways |
|
 |
|
 |
|
 |
|
Hinge type chip conveyor is standard. Other type chip conveyor is standard. Other type chip conveyor is available as an option.※Magnet Scraper, Rolling Drum Filter, etc. |
|
The hydraulic unit has an energy saving pomp that comes with an inverter motor. |
|
To ensure high accuracies and long life, each model is equipped with Box-Shaped slide ways. Mating surfaces are covered with special synthetic resin. The ball screws are forced lubricated. Telescoping steel covers protect the ways and screws from chips, coolant, and debris. |
|
|
| Built-in high speed gantry type part loading system. |
|
This very reliable loading system has a 1-Arm / 2-Grippers on the loading arm.
It is also equipped with a 90 degree part turn-around device right above the loading spindles, and work-pushers in the package.
Both sides of the part can be simultaneously machined utilzing this feature. |
 |
|
Operation Panel |
| The tool posts on each slide are independently displayed on the central control panel. The swivel pendant arm make it easy for the operator to set up the machine. |
 |
|
| Pendant panel to be used for the part loading system. |
|
Teaching in and manual operation of the loading system are to be done on the same Control panel.
The basic 8 pattern modes of the loading system are in the control unit.
Selecting the pattern of the loading system mode can be easily selected and programmed. |
|
|
Designed with three totally isolated areas |
Upper:Part loading arm area. Middle:Part loading on the chucks. Bottom:Machining area.
|
 |
 Part loading arm area
World's fastest loader is eqquipped with work reversing unit. |
 |
| Work Reversing Unit |
|
 |
| Loading/Uniloading |
|
|
|
Part loading on the chucks
Parts are loaded and un-loaded on upper two spindles while lower two spindle are machining parts. |
Machining area
Lower two spindles work simulataneously machining either two identical parts or front and back of parts. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
